Test devices and sample size DIN 4102-1

TEST	SAMPLE SIZE	CRITERIA
Fire cabinet test	90mm x 190 mm (edge test) 90mm x 230 mm (surface test)	Propagation of flames within 20 sec. flaming droplets/particles
Fire shaft test	1.000mm x 190 mm (maximum sample thickness 80mm)	destroyed surface Residual length Flue gas temperature further observations: Integral of the smoke development/emission flaming droplets/particles
DIN-750°C-oven	40mm x 50mm piled up to a sample thickness of 40mm	Temperature increase Development of flammable gases
Alternative: Calorific value test	Approx. postcard size sample	4,2 MJ/kg 16,8 MJ/m2
Smoke development/emission due to stress caused by flames	30mm x 30mm (maximum sample thickness 15 mm)	15% light attenuation
Smoke development/emission smoldering conditions	270 mm length x 2mm width x 5 mm thickness and / or 270 mm length x 5mm width x 2 mm thickness	30% light attenuation

Test devices and sample size DIN 4102-14

TEST	SAMPLE SIZE	CRITERIA
Floor test	230mm x 1.050mm	Propagation of flames Integral der smoke development/emission

Test devices and sample size for European tests for the classification according to EN 13501-1

TEST	SAMPLE SIZE	CRITERIA
Small burner test according to EN 11925-2	90mm x 250 mm (edge and surface test)	Propagation of flames within 20 /60 sec. flaming droplets/particles
SBI-test according to EN 13823	1.000mm x 1.500mm (large sample wings) und 1.000mm x 500mm (small sample wings)	FIGRA (heat release rate) SMOGRA (smoke release rate) further observations: Lateral propagation of flames flaming droplets/particles
750°C-oven test according to EN 1182	Cylinder with an outside diameter of 45mm height 50mm	Temperature increase Loss of mass Continued burning
Calorific value test (Calorimetry)	Approx. postcard size sample	2 MJ/kg respectively 3 MJ/kg 1,4 MJ/m•m2 respectively 4 MJ/m•m2
Floor testaccording to EN 9239-1	230mm x 1.050mm	Propagation of flames Integral der smoke development/emission

Sample size for examinations of roofings for the classification according to DIN 4102-7 or EN 13501-5

TEST	SAMPLE SIZE	CRITERIA
Resistance to flying sparks and radiant heat DIN 4102-7 or CEN/TS 1187 test method 1	800mm x 1.800 mm (with and without joints)	Propagation of flames on the surface and inside the component. Passage of flames through the component.
Exposure of roofing by fire from the outside CEN/TS 1187 test method 2	400mm x 1.000 mm	Length of the damage of roof membrane and support plate.

TEST DEVICES